davidaltmejd.com is a participant in the Amazon Associate program, we may earn a small commission from the qualifying purchases of our recommended links. Learn more.

How Much Does a Honda Accord Engine Mount Replacement Cost (DIY Steps + Bad Mount Symptoms)

The engine mount is as important as any part of the car because it holds the most critical part of it, which is the brain of the vehicle, the engine.

As time goes by, this thing will eventually get old and retire just like any part of the car, and of course, with its importance to the vehicle’s brain, a Honda Accord Engine mount replacement is an important thing to do.

In this article, we will tackle the Honda Accord engine mount replacement cost and know if yours needs it.

This is an important thing to discuss since the engine mount has a particular connection to the car’s engine.

There are many ways to know if your engine mount needs a replacement; here are some things that you need to look out for.


Symptoms Of A Bad/Broken Mount of Honda Accord Engine

There are many ways to know if your engine mount needs a replacement; here are some things that you need to look out for.

Excess Noise

If you notice that your engine is making some unusual and excessive noise, although not every time it’s all about the mounted motor, it’s one thing to look out for.


One sign that your engine mount needs a replacement if you feel an excessive vibration. This vibration is not just a sound, and you will actually feel it. This is because the vibration dampening effect is long gone.


The purpose of the engine holder is not only to hold the motor but also to align it properly. One indication that you need a new one is when you notice that the engine is unelevated properly.

Defective Belts and Hoses

It can also damage the other parts connected to the engine, which are the belts and hoses.

Damage to the Engine

This may not be the most common symptom, but this is an angle that you need to consider. A broken engine mount can damage the engine itself because it can bounce side-to-side, which can cause some damage to it.

Can You Drive With Bad Mount?

With a few inches of movement, driving is still possible and safe to do. However, if the activity is getting worse each drive, you have to replace it immediately.

A visual check is necessary, so you can determine the status of the mount.

Honda Accord Engine Mount Replacement Cost

Replacing your Honda accord engine mount will happen eventually, so even if you experienced this type of situation or not, you might have to know how much it will cost you if you do a replacement.

If you are planning to DIY the replacement,  the cost of the mount alone is from $250 and more.

If you are thinking of hiring someone or getting help from professionals, aside from the $250 for the mount, you will have to pay a labor fee from $75 to $100.

A rough estimate of $250 for DIY and $325 for the other way of replacement.

DIY Cost

Doing the process all by yourself can only cost you a minimum of $250; this is the price of the engine mount alone.

This estimated price is only for people who have the complete tools needed.

The price will go up if you need to purchase not just the mount; for example, buying new tools for the project and many more.

If the time for you is money, it will also cost you some time, especially if you are inexperienced and novice.

Overall, the project will not cost you more than $300 if you only need the mount replacement.

Professional Cost

The professional cost will always be more expensive than the DIY. The estimated total minimum charge for the replacement will be $325, and it can cost you more depending on who will work on the replacement.

The cost will also depend on how complex the replacement will be, and if you think that yours is pretty much in a bad situation, expect to pay over $500 for the total bill. The labor can go up to $400 or even more.


Changing the car engine mount will only take an hour to replace, but this is only per mount, and it will depend on the difficulty level of the damage.

Some professionals take 8 hours maximum for all the replacements, and they are all professional and experienced.

The process can take much longer for people who don’t have any idea or with minimal experience.

So, if you are going to change the mount, make sure to give a whole day or enough time for this.


  • Piece of 2×4 wood
  • Breaker Bar
  • Socket
  • Wrench
  • Flat Head Screwdriver
  • Spray Lubricant
  • Gloves
  • Extensions
  • Floor Jack

Honda Accord K1968 Fits 2008-2012

Highlighted Features:

  • 7 pcs full set
  • Made of steel and rubber material
  • 2.4L

The product comes with a complete seven-engine mount for a 2.4L size made of steel and rubber. These materials ensure the durability and longevity of the mount.

The package includes a front motor mount, left and right front center suspension mount, front right motor mount, rear auto motor mount, lower auto, and upper transmission mount.

Engine Mount Replacing Steps

DIY engine mount replacement is possible, and if we are here to help you do it with the simple step-by-step guidelines that we made.

  1. Get the car into a level surface and make sure to put in a handbrake, so the vehicle will not slide and cause an accident. Additional safety for your vehicle is by adding chalk blocks in the rear wheels.
  2. Open your Honda accord car hood.
  3. Locate the car engine mounts on the bottom of each side of the engine. You can quickly determine it since it’s a black rubber mount with a metal bolt that connects it to the frame.
  4. Raise the vehicle using the jack. Leave it under the wheel side you are onto. Do this on both sides, which will take the front end of the car off the ground.
  5. Remove the bolt with the pliers, socket, and ratchet.
  6. Lift the mount using the flat head screw, or if you have a pry bar, you can use that too. If the mount is stuck, this is an optional way; you can use the WD-40 to remove it.
  7. Remove the mount from the housing and set it aside.
  8. Get the new mount set, and place it on the location where you remove the old one.
  9. Insert the bolt and tighten it using the ratchet and socket. Make sure that it is tight and will not easily fall off because it can cause some damage to your engine.
  10. You can apply this process to other engine mounts and finish it.

Here is a video that you can use for visual guidelines.

Common problems of Honda Accord Engine

  • Ignition Failure
  • Check Engine Light Flashing
  • D4 Lights Flashing
  • Air Conditioner Blowing Warm
  • Faulty Doors


How Many Motor Mounts Does a Honda Accord Have?

There are different sets of motor mounts on every batch of honda accord. Usually, these cars needed four engine mounts.

These are the main side engine, thrust front engine, thrust transmission, and the main transmission mount.

How To Check Engine Mounts

Since the engine mounts connect to the engine, things will go wrong once they become faulty.

You must check your engine mount once in a while. Most of the time, you will feel the symptoms of the defective engine mount.

You can check it by opening the hood and locating the engine mount location. Usually, they are on the sides of the engine.

You can ask for some assistance to turn on the engine and let it run.

If the motor moves, then there is a possibility that your mount needs replacement.

What Are The Signs That You Need To Replacement Your Engine

Increased Vibrations

This is the most common symptom that a faulty engine mount usually does.

You will feel it when the vehicle is in use and the engine vibration is constantly increasing.

The engine will make more noise than the usual sound that it produces, which is a clear sign that you need to replace the worn-out engine mount.

Rocky Start

When you start the machine, this is the time when you will feel an unnecessary lurch that does not feel normal or sound healthy to you.

This one is another common symptom, so worn engine mounts will need a replacement immediately.

The lurch is not only within the start; you can also experience this when turning off the ignition, so always look onto that as well.

A Bumpier Ride

You can also feel a jolt when you are driving faster. The faster you go, the more it’s noticeable because the engine works harder during those periods.

Your car’s machine should be smooth, and if you feel any jolt, that is one clear sign of something wrong with your engine, which might be the engine mount.

 Impact Noises

If you hear any noises like clunks and bangs within the surrounding of the engine bay, you might have a worn engine mount.

The noise is because the engine is moving than its usual routine and in contact with the other parts of the car.

This causes impact noises that are very easy to notice.

Unusual engine noise can always mean that there is something wrong with the motor, and one reason is a faulty mount engine.

Visual Wear

Checking the mount itself is the best way to see if it has some damage.

The metal part of the mount changes it appears once it becomes faulty.

One sign that it needs change is if you see any corrosion or cracks in the part. In the rubber part, cracks or flaking indicate that your mount is good to go and say goodbye.

What would cause a motor mount to break?

Breaking or damaging a motor mount is a prevalent issue for any car. If you experience a problem like this, it’s very easy to solve. But, the question is, how does this happen?

The most common reason for this is because of aging. Anything that grows old will eventually break because of age.

The temperature has something to do with it; since it uses rubber and metal, these components can withstand the weather changes, but only for a limited time.

It can also be depending on how you use the vehicle. If you abuse the engine like driving aggressively, this can cause the mount to wear out easily.

This is because once you step on the pedal and the torque in the engine moves aggressively, the motor mount will get stressed.

The defective mount can also be a reason. Maybe when you change the motor mount, you installed a defective one, which is why its life is only short.

How often do motor mounts fail?

This will depend on how you use the car. But the typical lifespan of this is from 5-7 years. Of course, getting it checked is the best thing to know if your car has a healthy motor mount.

As long as the engine goes smoothly every ride, you have nothing to worry about.

But if you think that you are using it aggressively and you feel something is wrong under the five years, it is still possible that you are experiencing a broken mount.


You are checking your engine mount is very important since this is like the skeletal system that holds the car’s brain, which is the engine.

Without it, the machine will not function very well and can lead to more severe damage.

Replacement is the best thing to do since reusing the used and damaged ones is no good. It will save you from more severe car engine damages that can cost you more than it should only be.

Whether it’s a DIY replacement or getting help from a professional, both will save you from something more serious.